Alternatively, it might work for some CDs and not for others.įrom the user's point of view the player initially starts becoming temperamental, and then stops working completely and unable to read any disc.Service manuals and schemes for car electronics, car stereo, car video and car navigation. It might work one minute, but not work the next. Its operation becomes sporadic, which can confuse the user. When it is reaching the end of its useful life, and about to fail, it becomes, unstable. This is a shame, as one would expect high-end players to have better components for the mechanism however, it is usually the same cheap mechanism found in unbranded supermarket models.Ī laser diode, being a semiconductor, fails in an interesting way. Moreover, most of those failed within a few years as well. I have come across many high-end players of recent time that use the same cheap mass produced drive mechanisms. Most of those early CD players would be hard to find as they often ended up in landfill. The laser diode manufacturing process was not as refined either, and those diodes had a short finite life to them. Moreover, if that did not fail, then the laser surely would. Most of those units used cheap motors where the brushes wore out within a few years. It would be very surprising to find a player still working from that era. Laser diodes do not last forever, especially on the early players manufactured in the 1980s. These two components are in constant use and wear out the most. If there is no red light, then the laser has failed.īack in the 1990s, I used to fix many of these and it was always either the spindle motor or the laser that failed. It is usually bright enough and visible from the other side of the paper. A piece of paper the size of a standard CD within the tray can also help, because when the tray closes, one can see the diffused red light on the paper. The laser light is bright enough that one can see the diffused red light from a distance obliquely. Obviously one should never look directly into the laser unit, you would have to be plain stupid if you did that. If cleaning the lens does not solve the problem then I make sure the laser is working. I normally clean the lens just in case there is dust on it obstructing the laser path. I normally do two things when this happens. If the laser has failed, then it will not be able to detect a CD and therefore the error message appears.
#Blaupunkt gmdat cdp manual manual
note you must purchase the service manual in conjunction with this file. this bulletin consists of symptoms and fixes for this model. On the back of the unit a white tag reads GMDAT CDP G, 87967309205112807. teac cdp6000 bulletin regarding change of cd mechanism service manual. On the front of the unit it says RDS DMS 4 x 40W, Compact disc digital audio. Ive tried all the other buttons with no success. The top left button removes the unit face. This is the time when it is looking for a disc. Usually it is the top right button, but that doesnt eject the CD. This can be infuriating because you can see that there is a disc, however, the CD / DVD player cannot.Įvery time the tray closes, the laser beam fires two long bursts of laser light, and the focusing platform moves up and down attempting to focus the beam. If you are getting a NO DISC error on a CD / DVD player, then chances are the laser has failed.Ī typical symptom is you insert a disc in the player and after a while the CD tray opens again with the message referring to no disc being in the system.